Super clear polyester film with a optically clear, low tack, removable acrylic adhesive. The clear film can be applied and then removed from glass, acrylic and other similar surfaces without leaving a residue and offers a very “glass clear” look and finish. Perfect for window decoration graphics, Point of Sale, mock ups, signage, decals and labels. It offers superior water and wet smear resistance as well as good light stability. The film is tear resistant and offers very good see through clarity and good dimensional stability.
Articlenr. 2079C.105.35900
Characteristic |
Suitable for Piezo Ink Jet printer Suitable for Eco Solvent Ink Suitable for Solvent Ink Good ink absorption High visual contrast Light-fast and wet smear resistant prints Coating on print side is slightly matted for good roll transport in the printer Fast ink drying (if necessary activate heating system in the printer). Clear-transparent Ink jet coating Film can be removed again wthout leaving any adhesive residue on the applied surface Reverse side has a high transparent acrylic adhesive. Brillant and vibrant colors prints High visual contrast
|
|---|
Specifications |  | Coating frontside | For Ink Jet Eco Solvent and Solvent |
|---|
| Coating backside | High clear acrylic coating high (solvent based) |
|---|
| Print side | Slightly matt, rough side |
|---|
| Back side | Release liner: white translucent polyester film |
|---|
| Base material | Clear transparent polyester film |
|---|
| Width (mm) | 610 |
|---|
| Length (m) | 20 |
|---|
| Width (inch) | 24.02 |
|---|
| Length (ft) | 65.62 |
|---|
| Base/Nominal thickness (mm) | 0.075 |
|---|
| Base/Nominal thickness (mil) | 3 |
|---|
| Total thickness (mm) | 0.150 |
|---|
| Total thickness (mil) | 6 |
|---|
| Packing quantity | 1 |
|---|
|
|---|
Compatibility |
Useable on most large format Ink Jet printers using solvent ink systems (Eco-, Light-, Mild- Solvent inks and similar inks). Not recommended for printing with oil, water based or latex inks.
|
|---|
Handling |
Between 15-30°C and 30-70% r.h. A preconditioning period of 24 hours within the printing environment is recommended.
Avoid fingerprints on printing side. Heating system in printer possible up to approx. 48°C. Higher temperature may cause film deformation. Lamination: cold or heat laminates (low-temp) possible but not necessarily essential. Ink Load: approx. 220 - 280 % (may vary according to ink system and RIP calibration). Dry and wet adhesive surface applicaton possible Reidue-free removal Further information on this product can be found in a separate handling instruction
|
|---|
Storage |
Store in a cool and dry place at a room temperature of 15 - 25°C and at a humidity of 30 - 60%. Unopened in original packaging storage time is minimum 1 year after shipment (under recommended storage conditions).
|
|---|
